|
|
![]() ![]() |
|
![]() ![]() ![]() ![]() |
|
Опции темы | Поиск в этой теме |
![]() ![]() |
![]() ![]() |
Модератор своих разделов
Регистрация: 03.07.2010 Последняя активность: 10.10.2022 08:53
Сообщений: 1652
Сказал(а) спасибо: 0
Поблагодарили: 2984 раз(а) в 1024 сообщениях
|
![]()
Ravpower RP-BC015
![]() ![]() ![]() A four slot NiMH only charger from Ravpower that is USB powered. ![]() ![]() ![]() The charger was in a cardboard box without much information. ![]() The box included the charger, a USB cable (Flat type), a instruction sheet and 8 AA NiMH batteries. ![]() The charger has a micro USB input. It only uses 5V and the supplied cable is with a USB-A plug in the other end. ![]() There are no buttons, only a fairly dim led for each slot. The leds is red while charging and green when the battery is full. ![]() The charger has specifications on the back. ![]() ![]() ![]() The connection are the common two level style for AA and AAA batteries. ![]() ![]() ![]() ![]() Measurements
![]() With a single battery the charger current is nearly 2A, it looks like it terminations on voltage and there is no top-off or trickle charge. ![]() ![]() ![]() The 3 other slots are similar, but for some unknown reason I have a lower charge current in them. ![]() ![]() ![]() The 3 high capacity cells are charged fine, but the curves make me doubt the termination is just voltage, the charger may be smarter than that. ![]() With AAA batteries the current is reduced to 1A, again the charging looks fine. ![]() A full cell is detected in about 5 minutes, this is fairly fast. ![]() The charger was not that happy about a weak charger or long cable (The leds where not stable). It charged the batteries fine enough, but the termination was a bit slow. ![]() With full power input the charger uses 0.5A charging current for all four batteries. ![]() M1: 35.6°C, M2: 39.4°C, M3: 40.4°C, M4: 37.1°C, HS1: 53.2°C ![]() M1: 38.0°C, HS1: 45.7°C ![]() The charger is starts in about 2 seconds when power is applied. ![]() The charger only has 1 charge circuit and will switch it between the slows. With one slot in use it will get all the charge current. ![]() ![]() ![]() With more slots in use the charge current will be distributed between the slots. ![]() The charger will not work reliable with a unstable voltage. Conclusion This is a compact charger with a total of 2A charge current, that is distributed between the batteries in the charger. This means a single battery will be charged fast and four batteries will take four times as long. It passed all my test without any trouble, this makes it a good charger. Notes Ravpower batteries review Here is an explanation on how I did the above charge curves: How do I test a charger My USB charger tests
__________________
My website with reviews of charges, batteries and other stuff: http://www.lygte-info.dk/ |
![]() |
![]() ![]() |