Светодиодные фонари и световые приборы. Всё о светотехнике.
Вернуться   Форум FONAREVKA.RU Обзоры фонарей Flashlight Reviews
Расширенный поиск
Забыли пароль? Регистрация

  • О нашем проекте
  • Светотехника и световые приборы
  • Правила форума
Проект FONAREVKA.RU специализируется на предоставлении всей необходимой информации по светотехнике:

— светодиодные фонари;
— различные источники питания;
— разнообразные зарядные устройства;
— освещение помещений и наружное освещение;
— световые приборы для личного, пассажирского и грузового транспорта;
— специальные световые приборы для медицины, для растений, для аквариумов, для террариумов, а также аварийно-сигнальные световые приборы;
— альтернативные источники света;
— лазеры и лазерная техника.

Если у вас есть вопросы по выбору фонарей, аккумуляторов и зарядных устройств ознакомьтесь с FAQ от наших экспертов:

F.A.Q. по выбору фонарей различных типов;
F.A.Q. по выбору аккумуляторов;
F.A.Q. по выбору зарядных устройств.
Ответ  Создать новую тему
Просмотров в теме 7711   Ответов в теме 3   Подписчиков на тему 2   Добавили в закладки 0
Опции темы Поиск в этой теме
Старый 04.07.2010, 16:52 Автор темы   1
Модератор своих разделов
 
Аватар для HKJ
 
Регистрация: 03.07.2010
Последняя активность: 10.10.2022 08:53
Адрес: Copenhagen, Denmark
Сообщений: 1652
Сказал(а) спасибо: 0
Поблагодарили: 2981 раз(а) в 1024 сообщениях

По умолчанию Review of Mr.Lite SS2 Stainless steel light

Mr.Lite SS2





Mr.Lite is a manufacturer with a broad selection of lights, here I am taking a look on a stainless steel light. This light is shooth tube in shape and uses the full Mr.Lite user interface (See below).
I received only the light, no box or accessories was supplied for the review.



The light has an OP (Orange peel) reflector with a Cree XR-E led in the center.



It is possible to open the front of the light.



Looking into the battery tube, the connection for the battery + pole can be seen, it is a solid piece of metal.



The stainless steel body has a discrete Mr.Lite marking on it. That is the only marking on the light.



The tail has a reverse switch with a stainless steel button. It is a long tailcap and the treads on the tailcap are very nicely done and works smooth.



The inside of the tailcap has a spring with a cap on for connection to the battery, again very nicely done.



Here is the complete light with all parts it can be dismantled in without tools.



The standard user interface has lots of settings, but is missing a real low.



This light is a solid stainless steel light and can probably take just about any kind of abuse (Not tested). The build quality and finish is good, but the brightness is not in the top range. The long list of modes in two groups is also a minus for me.



Technical specification and measurements



The driver is designed to work on CR123 batteries, but the light will also work on LiIon batteries.

Measured size and weight:
Length: 95.6 mm
Diameter: 24 mm
Weight: 187 gram with CR123 battery

The light uses a Cree XR-E led.

The light has 5 brightness settings, controlled with pwm and 4 flashing modes



I have collected all modes in a table. For the brightness I used a luxmeter and then scaled the values, the pwm is measured with my oscilloscope and a light sensor, the current with my DMM on peak/average (Fluke 289). For the estimated runtime I have take the current measurements and divided into 1.4 (i.e. a 1400 mAh battery), this is a very rough estimate.
PS: The , in the table is a decimal point.




Doing a voltage sweep and recording current and brightness shows that the light has a stable light output with CR123 batteries, but LiIon has to high voltage, it will go into direct drive. Because this light is running at a low power level (Around 1.5 watt from 1.7 to 3.9 volt and 2.5 watt at 4.2 volt), this helps keep the led at safe temperature with the bad heat transfer of stainless steel. This power levels also means that the light cannot reach the specified 230 lumen.



I did not do any runtime with CR123 batteries, they would be long and flat, instead I have done two with LiIon. The first part of the run is with direct drive. Later on when the battery voltage gets low enough, the regulation kicks in and keep the brightness stabilized until the battery is empty.
Note: The LiIon battery was measured to 530mAh



The light uses pwm at 280 Hz to regulate the light, but looking at the signal it contains other frequencies from the converter. The above trace is from low brightness (10% pwm).




#3 brightness with 60% pwm.



High brightness with 98% pwm.



The strobe is 14 Hz and uses 50% duty cycle




SOS uses a 0.5 second unit, it takes 13.5 seconds to send a sos and there is a 53 second pause between transmissions. The only difference between the two sos settings is the brightness.



The standby selection has a 0.05 second flash each 8.7 second.



Comparison to other Flashlights

Beamshots and a comparison to other lights can be found here.



Notes

The light was supplied by Mr.Lite for a review.
__________________
My website with reviews of charges, batteries and other stuff: http://www.lygte-info.dk/
HKJ вне форума   Ответить с цитированием Вверх
Старый 17.07.2010, 06:16   2
perfectful

 
Регистрация: 26.06.2010
Последняя активность: 26.08.2011 11:52
Адрес: China
Сообщений: 207
Сказал(а) спасибо: 0
Поблагодарили 1 раз в 1 сообщении

По умолчанию Re: Review of Mr.Lite SS2 Stainless steel light

This flashlight didn't see it before ,but a nice looking flashlight !
perfectful вне форума   Ответить с цитированием Вверх
Старый 17.07.2010, 07:52   3
awl
Ветеран Фонарёвки
 
Аватар для awl
 
Регистрация: 09.07.2010
Последняя активность: 23.05.2023 09:41
Адрес: Ижевск
Сообщений: 3247
Сказал(а) спасибо: 206
Поблагодарили: 1040 раз(а) в 466 сообщениях

По умолчанию Re: Review of Mr.Lite SS2 Stainless steel light

Excellent review! what an oscilloscope you use?
awl вне форума   Ответить с цитированием Вверх
Старый 17.07.2010, 09:00 Автор темы   4
HKJ
Модератор своих разделов
 
Аватар для HKJ
 
Регистрация: 03.07.2010
Последняя активность: 10.10.2022 08:53
Адрес: Copenhagen, Denmark
Сообщений: 1652
Сказал(а) спасибо: 0
Поблагодарили: 2981 раз(а) в 1024 сообщениях

По умолчанию Re: Review of Mr.Lite SS2 Stainless steel light

Цитата:
Посмотреть сообщение Сообщение от awl :
Excellent review! what an oscilloscope you use?
I am using a PicoScope, they are not the cheapest usb scopes, but a good one.
HKJ вне форума   Ответить с цитированием Вверх
Ответ  Создать новую тему
Опции темы Поиск в этой теме
Поиск в этой теме:

Расширенный поиск





Copyright ©2007 - 2024, FONAREVKA.RU

Powered by vBulletin®
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd. Перевод: zCarot

Правила форума | Отказ от ответственности

Время генерации страницы 0.09534 секунды с 18 запросами