|
|
|
5278 9 7 0 |
|
Опции темы | Поиск в этой теме |
15.01.2016, 19:31 | 1 |
Модератор своих разделов
Регистрация: 03.07.2010 Последняя активность: 10.10.2022 08:53 Адрес: Copenhagen, Denmark
Сообщений: 1652
Сказал(а) спасибо: 0
Поблагодарили: 2981 раз(а) в 1024 сообщениях
|
Test/Review of Charger Skilhunt M1
Skilhunt M1
Skilhunt usual sells flashlights, but has recently started on chargers. This charger is a universal 1 channel charger that can handle multiple chemistries and battery sizes. It does also work as a power bank. I got the charger in a cardboard box with specifications on it. The pack contained the charger, a usb cable and a instruction sheet. The charger is powered from micro usb and has a full size usb connector for power bank output. The charger has two red leds to show selected current and four blue leds in a row to select voltage and show battery level. The button has multiple functions: When a battery is put into a powered charger, it can be used to select LiIon voltage (NiMH is selected automatic). When charger is powered a long press (2 seconds) will change between 0.5A and 1A charge current. A fast click when charging will show the selected battery type. When used as a power bank a press on the button will turn the usb power on. The charger uses the typical slider construction, it can handle batteries from 33mm to 70mm. The charger can handle 70mm long batteries, inclusive flat top cells, this means most protected cells. Measurements charger
Charging 4.20 volt LiIon The charger has a fine CC/CV voltage charge curve, it starts reducing current a bit early, due to voltage constrains, this will give slightly longer charge time. No surprise on these two cells. Reducing the charge current to 0.5A works fine, except the termination current is not reduced (Cells will miss the last few percent of the charge). With this older cell the current reduction starts very early as expected. Good charging on these smaller cell, again the higher termination current means a few percent loss in capacity. Adding a resistor in series with the usb power supply to simulate a long cable or weak supply did not prevent the charger from doing a good job, but it needed some more time. M1: 35,1°C, M2: 37,7°C, M3: 44,4°C, HS1: 48,3°C M1: 34,4°C, M2: 35,0°C, M3: 38,6°C, HS1: 50,5°C The charger needs some time to start up, this is because it is waiting for voltage selection. There is no problem with changing current while charging. Charging 4.35 volt LiIon The 4.35 volt charge works as expected. Charging 3.60 volt LiIon Both LiFePO4 cells is charged fine, but the voltage is a bit high (This is not a big problem with LiFePO4). Charging NiMH This is a good NiMH charge with -dv/dt termination and no trickle charge. Using 0.5A charge current the -dv/dt signal is nearly gone, but the charger do termination when the battery is full. On this cell it looks like a voltage termination. Here it is again a -dv/dt termination. This cell is nearly hopeless to termination on, but the charger did stop. The AAA cell is stopped on voltage. Fast detection of a full cell, this is voltage termination. M1: 33,7°C, M2: 40,0°C, M3: 31,9°C, HS1: 49,6°C The charger is also slow to start with NiMH, but it is not possible to select any other battery type. There is no problem with changing current while charging. The charger uses the typical pulsing, where it can measure voltage with current off. Power bank
USB output can deliver 1.3A before it starts dropping, the overload protection first kicks in at 2A. Running with 0.5A load looks very good. Increasing to 1A do have some problems the last 5 minutes, but generally works fine. The noise is fairly good at 0.5A load with 21mV rms and 200mVpp At 1A the noise increases, but is still acceptable with: 40mV rms and 310mVpp Conclusion The charger is not perfect, it has a few small issues, but nothing serious with any of the functions. This makes it a good charger for all supported batteries and also a good power bank. Notes The charger was supplied by Skillhunt for a review. Here is an explanation on how I did the above charge curves: How do I test a charger Read more about how I test USB power supplies/charger
__________________
My website with reviews of charges, batteries and other stuff: http://www.lygte-info.dk/ [Исправлено: HKJ, 16.01.2016 в 15:31] |
Поблагодарили: 25 раз(а) |
Artemha (16.01.2016), barena (15.01.2016), belsa (16.01.2016), blindnick (15.01.2016), Dima.shym (15.01.2016), ezuxen (30.01.2016), Garrik (15.01.2016), Georgiy (16.01.2016), m72 (19.01.2016), Magvay (15.01.2016), moto-moto (15.01.2016), PopovSergej (16.01.2016), ppi1 (16.01.2016), rpdoctor (16.01.2016), Svetogor (23.01.2016), Tamagotchi (15.01.2016), togico (15.01.2016), Vyacheslav Demeshko (27.01.2016), Waryag (16.01.2016), witalen (15.01.2016), wxp (16.01.2016), yurezz (15.01.2016), Алексей Михайлович (15.01.2016), Андрей Светлов (15.01.2016), _CKAT_ (15.01.2016)
|
16.01.2016, 09:02 | 2 |
Участник форума по OpenID
Регистрация: 09.03.2012 Последняя активность: 10.07.2021 17:32 Адрес: Копейск
Сообщений: 74
Сказал(а) спасибо: 29
Поблагодарили: 16 раз(а) в 13 сообщениях
|
Re: Test/Review of Charger Skilhunt M1
Skilhunt M1=LiitoKala lii - 100 and similar problems
|
16.01.2016, 11:50 | 3 |
Модератор своих разделов
Регистрация: 03.07.2010 Последняя активность: 10.10.2022 08:53 Адрес: Copenhagen, Denmark
Сообщений: 1652
Сказал(а) спасибо: 0
Поблагодарили: 2981 раз(а) в 1024 сообщениях
|
Re: Test/Review of Charger Skilhunt M1
I am working on the Lii-100.
|
Поблагодарили: 8 раз(а) |
AEDe (16.01.2016), Dima.shym (16.01.2016), m72 (19.01.2016), rpdoctor (25.01.2016), Svetogor (23.01.2016), Vyacheslav Demeshko (27.01.2016), Waryag (16.01.2016), Андрей Светлов (16.01.2016)
|
20.04.2016, 22:48 | 4 |
Увлеченный
Регистрация: 17.02.2015 Последняя активность: 13.02.2018 00:10
Сообщений: 51
Сказал(а) спасибо: 30
Поблагодарили: 4 раз(а) в 4 сообщениях
|
Re: Test/Review of Charger Skilhunt M1
Где найти перевод на русский язык,всего, что написано выше на марсианском?
|
20.04.2016, 22:51 | 5 |
Ветеран Фонарёвки
Регистрация: 26.04.2012 Последняя активность: 04.02.2024 09:42 Адрес: Оленеводск
Сообщений: 19454
Сказал(а) спасибо: 584
Поблагодарили: 10647 раз(а) в 5582 сообщениях
|
Re: Test/Review of Charger Skilhunt M1
|
20.04.2016, 22:55 | 6 |
Увлеченный
Регистрация: 17.02.2015 Последняя активность: 13.02.2018 00:10
Сообщений: 51
Сказал(а) спасибо: 30
Поблагодарили: 4 раз(а) в 4 сообщениях
|
Re: Test/Review of Charger Skilhunt M1
|
21.04.2016, 16:26 | 7 |
Новичок
Регистрация: 20.04.2016 Последняя активность: 04.08.2016 10:04 Адрес: БобруйскЪ
Сообщений: 18
Сказал(а) спасибо: 9
Поблагодарили: 2 раз(а) в 2 сообщениях
|
Re: Test/Review of Charger Skilhunt M1
|
21.04.2016, 17:41 | 8 |
_
Регистрация: 18.02.2015 Последняя активность: Вчера 01:52 Адрес: Псков
Сообщений: 4257
Сказал(а) спасибо: 2286
Поблагодарили: 2376 раз(а) в 1357 сообщениях
|
Re: Test/Review of Charger Skilhunt M1
barbosik, ит воз минт зат хиз нау тестинг лии-100 фо энозэ ревью
https://forum.fonarevka.ru/... |
21.04.2016, 17:48 | 9 | |
Новичок
Регистрация: 20.04.2016 Последняя активность: 04.08.2016 10:04 Адрес: БобруйскЪ
Сообщений: 18
Сказал(а) спасибо: 9
Поблагодарили: 2 раз(а) в 2 сообщениях
|
Re: Test/Review of Charger Skilhunt M1
Цитата:
|
|
21.04.2016, 17:58 | 10 |
_
Регистрация: 18.02.2015 Последняя активность: Вчера 01:52 Адрес: Псков
Сообщений: 4257
Сказал(а) спасибо: 2286
Поблагодарили: 2376 раз(а) в 1357 сообщениях
|
Re: Test/Review of Charger Skilhunt M1
barbosik, сравните даты непонятного поста и обзора литокалы, про это я вам и написал. Ну а чем он пользуется можно посмотреть по ссылкам в конце обзоров в т.ч. и на аккумуляторы.
|