Светодиодные фонари и световые приборы. Всё о светотехнике.
Вернуться   Форум FONAREVKA.RU Обзоры фонарей Flashlight Reviews
Расширенный поиск
Забыли пароль? Регистрация

  • О нашем проекте
  • Светотехника и световые приборы
  • Правила форума
Проект FONAREVKA.RU специализируется на предоставлении всей необходимой информации по светотехнике:

— светодиодные фонари;
— различные источники питания;
— разнообразные зарядные устройства;
— освещение помещений и наружное освещение;
— световые приборы для личного, пассажирского и грузового транспорта;
— специальные световые приборы для медицины, для растений, для аквариумов, для террариумов, а также аварийно-сигнальные световые приборы;
— альтернативные источники света;
— лазеры и лазерная техника.

Если у вас есть вопросы по выбору фонарей, аккумуляторов и зарядных устройств ознакомьтесь с FAQ от наших экспертов:

F.A.Q. по выбору фонарей различных типов;
F.A.Q. по выбору аккумуляторов;
F.A.Q. по выбору зарядных устройств.
Ответ  Создать новую тему
Просмотров в теме 2568   Ответов в теме 0   Подписчиков на тему 0   Добавили в закладки 0
Опции темы Поиск в этой теме
Старый 25.08.2012, 23:20 Автор темы   1
Модератор своих разделов
 
Аватар для HKJ
 
Регистрация: 03.07.2010
Последняя активность: 10.10.2022 08:53
Адрес: Copenhagen, Denmark
Сообщений: 1652
Сказал(а) спасибо: 0
Поблагодарили: 2981 раз(а) в 1024 сообщениях

По умолчанию Review of NiteCore SensCR with measurements and outdoor beamshots

NiteCore SensCR




NiteCore is a flashlight brand used by Sysmax. This light is the CR light in the sens series. The light is has 3 fixed brightness settings and a new innovative method to select brightness. The light is made of aluminum with hard-anodized (Type 3) finish.

All the sense lights:

Mini, CR and AA

My review copy did not include anything, but the light.



The light has a TIR optic, behind a glass lens.



The battery uses a brass insert with the circuit in. The foam provide anti rattle function and mechanical polarity protection.



Both the head and body has some knurling but without any bite in it.



The spring in the tail is a special type, without much movement.



The tail has holes for an O-ring and the light can also stand on the tail.



The user interface uses a tilt sensor, this is used to select between the 3 brightness settings when turning the light on. Holding it horizontal when turning on will give maximum brightness. Pointing slightly down or straight down will select the two other brightness levels. Pointing the light up will enable auto mode, where the light will adjust brightness when direction is changed between vertical and horizontal.
The light uses a slow turn on, i.e. it fades slowly up to the selected level and slowly up/down in auto. Horizontal position does always reach full brightness fast.



Here is all the part the light can be disassembled in without tools.


The new user interface is a interesting innovation, it makes it possible to turn a twisty light on in any brightness setting, turning on/off multiple times is not needed. But the interface is not intuitive, I tried the light on a couple of people and none could figure it out, without help.
Using the light I am not so happy about the slow turn on, except for that the sens interface works fine.



Technical specification and measurements



The light can be used with a CR123 or 16340 LiIon battery. The LiIon battery must be protected and not too long.

Measured size and weight:
Length: 66 mm
Diameter: 18.5 mm to 19.7 mm
Weight: 40.2 gram with a CR123 battery

The light uses a Cree XP-G R5 led.



In the above table I have collected all modes, measured at 2.5 volt. All the estimated runtimes are with 1400mAh CR123 battery.
Because my test bench requires the light to be locked in a fixed position, I could not compare the different brightness’s, this is also the reason I only did one voltage sweep.



A voltage sweep at high shows a good stabilization in the voltage range of a CR123 battery (1.5 volt to 3 volt), but not on a LiIon battery.



On CR123 the light has good stabilization, this can also be seen on the voltage sweeps.

There are no flashing modes and the light does not contain any pwm or noise.



Comparison to other Flashlights

4Sevens Qmini AA, NiteCore EZ AA, NiteCore SensAA:


Fenix E15, 4Sevens Qmini 123, NiteCore SensCR:


For the full comparison to other lights with graphs and beamshots see here





Notes

The light was supplied by NiteCore for review.
__________________
My website with reviews of charges, batteries and other stuff: http://www.lygte-info.dk/
HKJ вне форума   Ответить с цитированием Вверх
Ответ  Создать новую тему
Опции темы Поиск в этой теме
Поиск в этой теме:

Расширенный поиск





Copyright ©2007 - 2024, FONAREVKA.RU

Powered by vBulletin®
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd. Перевод: zCarot

Правила форума | Отказ от ответственности

Время генерации страницы 0.08885 секунды с 18 запросами